Dear Support Desk,
I’m a post-doc working on electrolyte-gated transistors. I have a question upon your setup, that I find really interesting. In the final step, it is written to connect this system to a SMU or potentiostat. I was wondering, how do you think to connect physically to these two equipments? In other terms, let’s suppose that I want to measure by using a potentiostat. Here, there are 4 terminals: source, drain, reference and counter and my potentiostat has working, reference, counter and sensing electrodes (apart from the ground). Which is the right way of contact them each others? On the other hand, it is not clear to me even by using a double channel SMU.
Thank you very much for your support.
Sincerely,
Stefano Casalini
Dear Support Desk,
I’m a post-doc working on electrolyte-gated transistors. I have a question upon your setup, that I find really interesting. In the final step, it is written to connect this system to a SMU or potentiostat. I was wondering, how do you think to connect physically to these two equipments? In other terms, let’s suppose that I want to measure by using a potentiostat. Here, there are 4 terminals: source, drain, reference and counter and my potentiostat has working, reference, counter and sensing electrodes (apart from the ground). Which is the right way of contact them each others? On the other hand, it is not clear to me even by using a double channel SMU.
Thank you very much for your support.
Sincerely,
Stefano Casalini